DRYPRO, HALF LEG CAST COVER

Latex Cover

Model #

Arm/Leg Circumference

Length

X-Small Full Leg

FL-12

7.5 – 11 inches

19 inches

Small Half Leg

HL-13

10 – 13 inches

21 inches

Large Half Leg

HL-15

13 inches & up

23.5 inches

Small Full Leg

FL-14

14 – 16.5 inches

29 inches

Medium Full Leg

FL-16

16.5 – 21 inches

33 inches

Large Full Leg

FL-18

21 inches & up

37 inches

*Keep in mind, to achieve the best fit, consider both half and full sizes.

Measuring Circumference: Measure the circumference of the arm or leg at 2 inches above the cast. If the end of the cast is very close to the elbow/knee, then measure mid-bicep/mid-thigh. Do not measure around the cast! Only measure around the skin of the arm/leg above the cast.

Measuring Length: Measure from the tip of the middle finger or heel of the foot to the top end of the cast. It is okay if the cast protector measurement is longer then the limb measurement. The protector will still work. Extra length will be removed when the vacuum seal is created.

Stretch on the DryPro Leg Cover: Pull over the leg to see how it fits. If the DryPro is too tight, you can trim 1/4 inch along the lines towards the top of the opening and try it on again. Be sure not to trim too much, as a tight seal is needed for the vacuum to work. Stretch the DryPro over the cast or wound so the top fits smooth against the skin. Allow some slack as the vacuum will remove the excess material.